User Tools
problems
This is an old revision of the document!
Table of Contents
Possible Problems
There are lots of possible problems. This page is a collections of some hints to find and fix possible problems.
Gun is not shooting
To find this problem put your system in continuous power mode. If the shooting LED of the gun is not on then you have a problem.
- Use an oscilloscope to make sure that the input to the transmitter board has an amplitude of 3.3V.
- Check the gun to make sure that the gun LED is working. A gun tester was built to help with this diagnosis.
- Check the supply voltage of your transmitter board.
You have to set the 'Fudge Factor' too high
With system set in You need to point the The 'Fudge Factor'
problems.1426794485.txt.gz · Last modified: 2015/03/19 13:48 by schultz
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
