ECEN 390 - Laser Tag Project

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Milestone 2, Task 3: Signal Processing of Complete System ======

===== Overview =====
This tasks involves put the various parts of the signal processing algorithm together.  This task will help you understand the signal processing algorithm and demonstrate that your signal processing algorithm works.

Essentially, this milestone combines Task 1 and Task 2 together.

===== General Requirements =====
  * Add a square wave to the optical noise
  * Decimate the signal
    * Filter the signal through using your low pass filter
    * Down-sample the signal to 
  * Filter the signal with the 10 bandpass filters
  * Calculate and display the power
 

===== General Notes =====
Measured signal from fluorescent lights: {{:light.zip|}}
player frequencies: 1471, 1724, 2000, 2273, 2632, 2941, 3333, 3571, 3846, 4167

===== Specifications =====
  - Low pass filter
    - FIR
    - length 81
  - Bandpass filters
    - IIR
    - length 11
    - Ten filters centered at player frequencies
===== Pass Off =====
Show the following plots for a shot by player 1.
  - Square wave for player 1
    - f=1471Hz
    - Amplitude of 0.1V (square wave with voltage of either 0 or 0.1V)
    - x-axis of 4 ms near the middle of the spectrum
    - y-axis of -1V to 1V
    - Sampling frequency of Fs=100kHz
  - Optical noise (from lights.mat)
    - Same axis as square wave
  - Sum of optical noise and square wave
    - Same axis as square wave
  - Decimated signal
    - Low pass filtered and then down-sampled to Fs=10kHz
    - Same axis as square wave
  - Signal filtered by bandpass filter centered at f=1471Hz
  - The power for the signal through all 10 bandpass filters
    - Signal length of 200ms

===== Resources =====
Here is the MATLAB code for creating the signal.
<code>
%Load in optical noise
load light 

%we only want 200ms of data or 200e-3*100e3 = 20000 sample
t=linspace(0,.2,20000)';
y=y(1:20000);

%create the square wave signal
freq=1471;
y1=0.1*(0.5+0.5*square(2*pi*freq*t));

%Add square wave to the noise
y2=y+y1;

</code>
ECEN 390 - Laser Tag Project

User Tools

Site Tools

Page Tools
