User Tools
milestones_and_schedule
Differences
This shows you the differences between two versions of the page.
|
milestones_and_schedule [2014/01/06 15:03] schultz |
milestones_and_schedule [2014/03/17 14:03] (current) schultz |
||
|---|---|---|---|
| Line 17: | Line 17: | ||
| - Pass/fail | - Pass/fail | ||
| - | ====== Milestone 1 ====== | + | ====== Milestones ====== |
| - | * Demonstrate operation of analog and digital portions separate | + | |
| - | ======= Milestone 1A ======= | + | [[Milestone 1]] |
| - | {{:m1a.pdf|}} | + | |
| - | * Objective: Demonstrate the operation of A/D and D/A | + | |
| - | * Configuration/inputs | + | |
| - | - Function generator (FG) connected to A/D PMOD | + | |
| - | - FG signal: 𝑉_1=1.5+0.05sin(2p 38 103 t) | + | |
| - | - Oscilloscope (OSC) connected to D/A PMOD | + | |
| - | * Pass requirements | + | [[Milestone 2]] |
| - | - 𝑉_2= 1.5+0.05sin(2p 38 103 t) | + | |
| - | + | ||
| - | ======= Milestone 1B ======= | + | |
| - | {{:m1b.pdf|}} | + | |
| - | * Objective: Demonstrate the operation of analog boards | + | |
| - | * Configuration/inputs | + | |
| - | - Function generator (FG) connected to transmitter board | + | |
| - | - FG signal: 𝑉_1=0.5+0.5sin(2p 38 103 t) | + | |
| - | - LED and photodiode separated by 20’ | + | |
| - | - Oscilloscope (OSC) connected to receiver board | + | |
| - | + | ||
| - | * Pass requirements | + | |
| - | - AC amplitude of V2>20 mV | + | |
| - | - Frequency of V2 = 38 kHz | + | |
| - | - Accomplished using FFT math function of the oscilloscope | + | |
| + | [[Milestone 3]] | ||
| + | [[Milestone 4]] | ||
milestones_and_schedule.1389045791.txt.gz · Last modified: 2014/01/06 15:03 by schultz
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
