Differences

This shows you the differences between two versions of the page.

--- gun_check [2016/03/14 09:04]
schultz created
+++ gun_check [2016/03/14 09:31] (current)
schultz
@@ Line 1: / Line 1: @@
 ====== Gun Check======
-There are three parts to the laser tag guns namely (1) shooting LED, (2) hit indicator LED, and (3) photodiode.  This device
+There are three parts to the laser tag guns namely (1) shooting LED, (2) hit indicator LED, and (3) photodiode.  This device{{:gun_checker.jpg?100|}}
-{{:gun_checker.jpg?200|}}
-can be used to test these three components.  The most common elements to fail is the shooting LED.
+can be used to test these three components.  Here is a picture of a gun connected to the tester.
+{{:gun_in_tester.jpg?100|}}
+The most common elements to fail is the shooting LED.
 Here are the steps for using the gun tester:
-**Step 1**: Plug the two gun cables into the tester.  (See Figure 1.)
+  - Plug the two gun cables into the tester.
-**Step 2**: Pull the trigger.
+  - Pull the trigger.
-**Step 2a**: Verify that the shooting LED comes on.
+  - Verify that the shooting LED comes on.
-**Step 2b**: Verify that the hit indicator LED (on the top of the gun) comes on
+  - Verify that the hit indicator LED (on the top of the gun) comes on.
-**Step 3**: Place the gun into the tester.  (See Figure 2.)  Make sure that the tester LED is aligned with the gun photodiode.
+  - Place the gun into the tester.   Make sure that the tester LED is aligned with the gun photodiode.
-**Step 4**: Pull the Trigger.
+  - Pull the Trigger.
-**Step 5**: Verify that the LED on the side of the gun tester comes on.
+  - Verify that the LED on the side of the gun tester comes on.

ECEN 390 - Laser Tag Project

User Tools

Site Tools

Differences

Page Tools